1, in the blast cleaning process should be more in the projectile region put the workpiece, thereby enhancing the clean-up efficiency but also reduce the wear and tear of the shield, an increase of its life.
2, in the case of the workpiece can not be increased, should be adjusted directional sets, so that the ejection of steel shot to make the most amount of projectiles on the workpiece, so that may also increase the life of the shield, reducing its wear.
A dust removal system should be adjusted throughout the branch pipe gate, so that the wind distribution reasonable, can enhance the effect of dust.
B dust collector should ensure regular cleaning.

Maintenance of equipment, shot blasting machine


After installation and commissioning into production at the same time, the equipment must be strictly according to its casting machinery necessary maintenance procedures maintenance.
1, all the oiling points of the equipment must be regularly according to their location requires the filling of engine oil, lubricating oil or grease.
2 seals (wearing parts) must be checked daily, such as damage to be replaced immediately.
3, the shield of the chamber body daily inspection, the damage should be replaced immediately.
4, the shield of the blast wheel, blades, impellers, directed sets, sub-pill round in each class for secondary inspection, if damaged, replace immediately.
5, the electrical system should be secondary inspections.
6, all transmission secondary inspections a week.
7, the operator cleaning effect should always check, if strange should immediately stop, and equipment to conduct an overall check.